Mustek PP3000 User Manual download pdf (Page 41)

4 - 1

PST-7000 series user’s manual – USING THE PST SYSTEM

USING THE PST SYSTEM

BEFORE POWER ON – A Check List

It is very important that you check the following operational points:

Ventilation

This terminal must NOT be operated in an environment with restricted

ventilation. The installation should be such that there is at least 25mm air clearance

around any top or side ventilation holes. The installation must also be such that there

is a free flow of air around the unit at ALL times.

Operating Environment

The equipment must not be operated or stored in extremes of both temperature

and humidity/moisture.

(Operating range 5°C to 40°C and up to 80% humidity – non condensing)

Power Supply

The operating voltage of the power supply should be checked to confirm that it

is set within the range of the local power supply. The power cable, the power outlet

and any power fusing arrangements must conform to local safety regulations.

Printer DC Power Supply

Please check that power supply polarity to the load is correct unless the printer

used is the Posiflex POS printer. Permanent damage may result if the incorrect

polarity is used.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 66 67

No comments

Mustek PP3000 User Manual Page 41