Mustek PP3000 User Manual download pdf (Page 40)

3 - 20

PST-7000 series user’s manual – BRIEF INTRODUCTION

AC POWER

The power supply operating voltage must be checked and altered if necessary.

This must be done WITHOUT any connection to the AC power.

The operating voltage adjustment switch is located between the two power

connectors in the rear compartment (Both connectors are standard IEC 3 pin

connectors, one is a power inlet and the other is a power outlet).

The switch should indicate either 115 volts or 230 volts. When set at 115 volts

the acceptable power supply voltage range is 90 volts to 130 volts whilst at 230 volts

the acceptable power supply voltage ranges from 190 volts to 260 volts.

The power supply cable should first be connected to the power inlet (but NOT

the wall socket). This cable should be secured to the latticed bottom of the rear

compartment using a cable tie provided. The cable may exit either at the side or back

of the rear compartment by using the relevant breakout section in the chassis plastic

molding.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 66 67

No comments

Mustek PP3000 User Manual Page 40