Mustek PP7000 User Manual download pdf (Page 28)

INTERNAL SWITCH

There is an extra internal 4 position DIP switch in PP7000-

II for more technical settings. To access these setup, please first

turn off the printer power and disconnect every cable from the

printer. Remove 4 screws from bottom of printer and remove the

plastic bottom cover with the power switch pressed. The 4

position DIP switch seats beside the 8 position DIP switch for

setup window with the switch position counting starts from the

nearest side to the 8 position DIP switch.

This 4 position DIP switch works as following:

Switch position Setting Effect

Function ON OFF

Print speed 42.5 lines / sec 28.3 lines / sec

Paper width 58 mm 80 mm

Line format 576 dots / line 512 dots / line

Reserved N. A. N. A.

For switch position 1, when it is set to ON, the printer runs

in high speed mode. This is the default setting as the printer is

delivered. However, depending on the print content (f.i. the

printer is used for printing bar codes that have to be dark enough),

it could be wiser to set the printer to work in power saving mode

by changing the switch to OFF. The printer could run smoother

and in effect faster due to elimination of motor brake application.

Switch position 2 is usually set to OFF for use with 80 mm

paper width. When the printer is installed with the 58 mm paper

guide adaptor for use with the paper roll of 58 mm width, the

switch should be set to ON in PP7000-II.

Switch position 3 is usually set to OFF for ESC/POS

command application that prints at 512 dots / line. Only technical

users shall set this switch to ON and make the printer work in the

576 dots / line format.

5 - 4

1 2 ... 23 24 25 26 27 28 29 30 31

No comments

Mustek PP7000 User Manual Page 28