Mustek PP7000 User Manual download pdf (Page 18)

Before putting back the paper roll for printing, alcohol

solvent must be dried completely.

TROUBLE SHOOTING

This section gives solutions to some printer problems you

may have.

1. General Problems

No LED lights up on control panel when switched on –

Make sure that the power supply cables are correctly plugged into

the printer, the power adaptor and to the power outlet. Make sure

that power is supplied to the power outlet. If the outlet is

controlled by a switch or timer, try use another outlet.

Printing Problems

Nothing can be printed with ERROR LED ON – Check

the Paper Out LED. If it is ON, most probably the paper roll is not

installed or is at or near the end. Install a new paper roll. If the

Paper Out LED is OFF, please check if the print hood is properly

closed. There are 2 internal check points inside the printer to

assure the locking of the hood for a decent printing. Therefore any

dislocation of the hood may cause an error status and inhibition to

printing. Press down the hood at middle of the opening when

closing it till it audibly clicks into place. If both situations are not

the cause, please try pulling the hood lock forward. If the top

hood won’t release automatically, check for paper jam described

in next item.

If there is no paper jam and the printer has been printing for

quite a period of time, the print head may be overheated. It will

usually cool back in few minutes and the printing will resume.

3 - 2

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 30 31

No comments

Mustek PP7000 User Manual Page 18