Mustek PP7000 User Manual download pdf (Page 12)

When to replace paper

Whenever the printer gives paper out signal or a red line

appears on the thermal paper, it is the proper timing for replacing

the paper. Do not wait till the print engine is dragging the paper

roll at the very end. Remove the leftover and replace a new paper

roll as illustrated above to prevent excessive paper dust in the

printer and consequently possibility for paper jam.

CONNECTING CABLES

1. Serial connection

All the external connectors are in the recessed area at the

rear bottom. The serial connector is a 9 pin D sub Female

connector at the right in the picture above. Apply the male

connector of RS232 cable to this port for serial application. Please

note that when serial connection is used, there must be no cable

connection at the parallel port on the printer. The default protocol

used in serial connection is 19200 bps, none parity, 8 data bits, 1

stop bit. Set in setup window the switch positions both 1, and 2

to OFF leaving the rest unchanged as factory default setting.

Parallel connection

The parallel connector is a 25 pin D sub Male connector at

the leftmost location in the connector area. Apply the female end

of the parallel cable at this port for parallel application. Please

note that when parallel connection is used, there must be no cable

connection at the serial port on the printer. Please also note that to

keep parallel interface in fast operation, please adjust in setup

2 - 2

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 30 31

No comments

Mustek PP7000 User Manual Page 12