Mustek PP7000-II Specifications download pdf (Page 41)

TP-5700/5800 series Technical Manual 5 - 9

at the very edge of screen display and making a movement to go outward from the

screen like a real mouse does.

EXIT

Clicking on this item saves all the parameters and exits the program.

POWER SWITCH MANAGER

POWER SWITCH SETTING

The function of the power switch that is at the lower part of the right side as

viewed in desktop application can be defined here. When “ON/OFF” function for this

switch is selected, the power switch turns the system on when the system is off and

turns the system off when the system is on. When “ON Only” function for this switch is

selected, the power switch always turns the system on regardless of the status

whether the system is On or Off. In this way, accidental switching off of the system is

avoided. However, the software power off per instructions given in page 5 - 3 of this

chapter or the “Posiflex Power OFF” function has to be engaged to turn off the system

in such approach.

UPS BATTERY STATUS

When the system is equipped with a valid UPS battery, the system will indicate

that the UPS function is “Enabled” to guard the system against intermittent power

failure. When there is no UPS battery installed or when the battery installed is already

out of service, the system will indicate that the UPS function is “Disabled” and the

system will immediately turn off to reject any possible noise or the consequent RTC

CMOS setup data loss when power fails. It is advisable to replace as soon as possible

an installed UPS battery but found out of service from this function.

POWER OFF DELAY TIME

This function defines the time delay between the software power off command

(Posiflex Power OFF) and the physical power off. The count is programmable between

1 and 255, and each count represents 1 sec delay. This software power off command is

an irrevocable process just like pulling the plug after a certain delay to allow the

shutdown procedures. So special care must be exercised in using this software power

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 68 69

No comments

Mustek PP7000-II Specifications Page 41